新闻详情

简析工业推拉门的安装

Slide when installed, must according to the width and direction of opening the door, the door beam or beam fixed to the canopy, door width center as the reference points, fixed should pay attention to the following points:

滑道同雨蓬梁或门梁连接处的左右标高一致,滑道相对于门洞中心尺寸一致。

Slide with canopy or beam connections of beam height are same, compared to the same size and center slide.

滑道中心线与彩板外墙或砖墙外边的尺寸一致,且其尺寸为门扇厚度的一半外加20mm的间隙

The same size slide with the center line of color plate wall or brick wall outside, and half the size of the door leaf thickness plus 20mm clearance

门扇及滑轮系统由公司在车间内加工成型。上滑道安装结束后,随即将滑轮成对放入滑道滑槽内,然后用人工或其它吊装工具将门扇竖直运到其下方,并将门扇上焊接的螺杆套入滑轮上的螺栓孔内,用双螺帽临时紧固

The door leaf and pulley system by the company in the workshop processing. Slide after installation, then slide chute into the pulley pair, and then use the manual or other lifting tool under the vertical to the door leaf, and the door leaf is welded on the screw sleeve into the bolt hole on the pulley, with double nut temporary fastening

门扇均已挂好后,将二个门扇均推到门洞中心位置,并将其贴紧,按室外地坪标高的要求,将门扇下扁钢调到地坪上表面0~10mm,同时调整两门扇连接处的缝隙到最小且侧边垂直于地面。标高调整用松紧上面的螺帽进行。门扇全部调整结束后,将滑轮上的止推销用开口销固定在滑轮上。

The doors are hung, the two doors are pushed to the center position, and the close, according to the requirements of outdoor ground level, the door leaf to the floor under the flat surface 0~10mm, gap junction and adjust the two doors to the smallest side and perpendicular to the ground. Elevation adjustment with the elastic nut. All the doors after adjustment, the pulley on the thrust pin secured with a cotter pin on the pulley.

门扇全部调整完后,将门扇分别全部关闭和推开,根据其位置,将上滑道底部或内部用角钢(上限位器)焊接在距离滑轮边10mm的地方,使门扇的开启区域限制在其有效范围。

All the doors after the adjustment, the door leaf were all closed and open, according to its position, will be on the bottom of the slide or internal angle (upper limiting device) welding at a distance of local 10mm pulley side, makes the door opening regional restrictions in its effective range.

BACK
map
联系我们:
云南省昌盈平开门有限公司
电话:
0875-628262
邮箱:
kgnyay@watfordjka.com

版权所有:云南省昌盈平开门有限公司, All rights reserved

地址:云南省保山市  电话:0875-628262  邮箱: kgnyay@watfordjka.com